![]() ![]() It was decided to use the following algorithm. In typical configurations, the mechanization of equipment separation in sessions has not yet been implemented, and in our case, when opening commodity documents by any user, 1C is trying to enable all the equipment connected to the current computer (in our case, it is 8 scanners and two Fri) naturally do this can not Which he happily informs the user with an indispensable number of errors. We did not work with us, because Used working groups and ports defeated without problems. Stroke support, when using the domain controller, for the correct conversions of the COM ports, it is necessary that the workstation entered the domain otherwise the port is not prohibited. If a small timeout is installed on the frame, then the installation of the parameters immediately from the terminal may not work, what the driver does not report.Īccording to information from those. And only then install the driver on the server and check the connection. Configure the exchange and timeout parameters, then transfer the selected parameters to the FR by pressing the button to set the parameters in the driver properties settings. ![]() When connecting the FR barcode in terminal access, for the correct operation of the FR in the driver, you must increase the timeout (depending on the speed of the order of 1000 ~ 3000 mc), I recommend installing the barcode driver at the beginning locally on the workstation. If there are other suggestions, ready to discuss. Now the following is implemented, the scanner was defined in all USB ports, then in the registry branch HKEY_LOCAL_MACHINE \\ SYSTEM \\ CURRENTCONTROLSET \\ ENUM \\ USB \\ Find the desired device, in it subordinate branches for each USB port, for each changing the FriendlyName parameter (affects only the device display in the task manager) and in the nested branch \\ Device Parameters \\ Change PortName parameter to the desired COM port number. There was another problem due to the fact that the scanners switch between the cash desk and the reception, when the scanner is returned, the COM port installed in the device manager installed in the device manager. Here the procedure is essentially similar, does not require problems with the support of the stand, but it is also necessary to translate the scanner to the "USB mode in COM emulation" by reading the code barcode and install the emulator driver at workstations. Because Several devices, then at each workstation, it is desirable to assist them with different COM port numbers that b with simultaneous connections they are not combed. Check that the ports are connected in the registry in the HKEY_LOCAL_MACHINE \\ Hardware \\ DeviceMap \\ Serialcomm branch or various utilities. In this case, if the barcode is not transmitted to the database, the scanner reports a long bip, successful transmission is accompanied by double beap.ĬOM port forwarding is installed in the ports check box on the RDP Local Resources tab.Īlso on the server it is necessary to verify the permission to connect the COM ports of the remote client: Administration Service Terminal Terminal Configuration, Client Settings tab:īecause The ports are virtual, then they do not appear on the server in the task manager, but they work correctly. When testing, the second mode did not always transmit data, the data loss in transmission were also noticed in the third one (apparently 1C does not have time to work out the stream of barcodes), left to work in the first mode. Modes are configured in the same way by reading control barcodes from the manual.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |